It is currently Wed Jan 17, 2018 10:15 am
Post your questions or tips on SheetCam software in this topic.
4 posts • Page 1 of 1
- Elite Contributing Member
- Posts: 1368
- Joined: Mon Jan 09, 2012 4:30 pm
- Location: New Berlin, WI
Go to the Help/About and make sure it is a licensed version.??
- Posts: 836
- Joined: Tue Feb 28, 2012 6:47 pm
A license is not required to do the first 150 lines of code unless its a pirated version. So you should get SOME code If you have operations defined with a tool and feed rates and have the contours on the layer associated with the operation. You should see the blue wider toolpaths as you define the operations. You have to select the correct POST processor to get code.
Who is online
Users browsing this forum: No registered users and 1 guest