Pierce only?

[tinman13]

I remember Jim Colt talking about going through and pre-piercing a job then change consumables to actually cut it.
Seems like it would be good for thicker plate.
Is there a way to do this in Sheet Cam? I have been searching for a while but haven't found it...

Thanks, Steve

[Brand X]

Not until Les makes a post processor for it.. Keep adding to the post, and Les will get around to it... He has been very good at improving SheetCam from the start...

http://www.forum.sheetcam.com/viewtopic.php?t=7059

[tinman13]

Hmmm.... might have to bug Les a bit!!

Steve

[Les Newell]

I uploaded a test post to the SheetCam forum.
http://www.forum.sheetcam.com/viewtopic.php?t=7059

[Brand X]

Thanks, Les..

I can't test it out for real at the moment, because I am working on upgrading my Z rail..

It's funny after all these years, nobody really asked for this feature? Like always, dealing with You, and SheetCam is one of the best experiences on the net.. Awesome support from day one..13-14 years for me...
Thanks, again..
Scott

[acourtjester]

Thanks Les
very easy addition, found the new button as shown.

less.jpg (19.51 KiB) Viewed 918 times

[motoguy]

Downloaded! Thanks Les, can't wait to give this a try.