I cut a lot of rectangular nameplates from 22 gauge sheet metal that are 12" x 4". Each plate has a .1" hole centered on the plate and .5" from each end. When I save in Corel draw as a PLT there is no line connecting the two holes. However, when I open the file in Command N Cut there is a line connecting them. If I delete the line the holes are also deleted. Anybody have any ideas what is going on?
Also, I have another plot that has three one inch tabs on a 24 " rectangle. In Corel draw it is fine but when I open it in Command N Cut the top of the top tab's left corner traverses at a 45 degree angle to the bottom of the right side of the tab. I have redrawn the plot twice and when I open it in CNC the diagonal line is still there. Very frustrating.
It is currently Thu Apr 19, 2018 1:26 pm
Post your questions or tips on Tracker software in this topic.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest