It sims on the screen no problem, shows the hole and everything. I see mach freeze for a second then jump lines.
THis code fails everytime....
Code: Select all
G00 Z0.5000
X-3.4678 Y2.6805
Z0.1000
M888
[b]G01 Z0.0000 F40.0
X-3.5613 F30.0[/b]
G03 X-3.5613 Y2.7159 I0.0748 J-0.0283
X-3.5660 Y2.6965 I0.0748 J-0.0283
G01 X-3.5560 Y2.6954
(Operation: Outside Offset, Colour 2, T1: Plasma, 0.035 in kerf)
M999
Code: Select all
G00 Z0.5000
X-3.4678 Y2.6805
Z0.1000
M888 (probe and start torch)
[b]G01 Z0.0000 F40.0
X-3.5613 Y2.7159 F30.0[/b]
G03 X-3.5613 Y2.7159 I0.0748 J-0.0283
X-3.5660 Y2.6965 I0.0748 J-0.0283
G01 X-3.5560 Y2.6954
(Operation: Outside Offset, Colour 2, T1: Plasma, 0.035 in kerf)
M999 (stop torch, lift up)
Any solutions>? Now I've got into just slightly rotating my whole cutsheet like 0.01 deg to make sheet cam gen 2 coord lead ins.