thc help

Mach3 and Mach4 questions, tips and topics can be posted here
Post Reply
kbenz
3 Star Elite Contributing Member
3 Star Elite Contributing Member
Posts: 465
Joined: Sun Oct 31, 2010 1:26 pm
Location: Kannapolis,NC
Contact:

thc help

Post by kbenz »

as far as I know I'm doing what I've always done. ran some 3/16" 45amp and 16ga finecut with the same issue. torch touches off and fires (with ohmic sensor) returns to cut height. starts cutting then starts raising as it cuts. I had to cut my volts back almost to half to finish the job at a close to correct cut height. Is there a setting I might have changed?
CandCNC
Mach3
Sheetcam
Draftsight
Hypertherm 65 machine torch
Millermatic 210
Passport plus
Spoolmate 150
Miller Bobcat 225
http://benzweldingandfabrication.com/
https://www.facebook.com/pages/Benz-Wel ... 468?ref=hl
Rtodahl01
2 Star Member
2 Star Member
Posts: 71
Joined: Mon Oct 02, 2017 3:39 pm

Re: thc help

Post by Rtodahl01 »

I have the same issue
Post Reply

Return to “Mach3 & Mach4 CNC”