It is currently Sun Sep 23, 2018 4:44 pm

 

thc help

Mach 3 CNC from Artsoft questions or tips can be posted to this forum.
kbenz
Posts: 428
Joined: Sun Oct 31, 2010 1:26 pm
Location: Kannapolis,NC
Contact:

thc help

Postby kbenz » Sat Jul 04, 2015 11:59 am

as far as I know I'm doing what I've always done. ran some 3/16" 45amp and 16ga finecut with the same issue. torch touches off and fires (with ohmic sensor) returns to cut height. starts cutting then starts raising as it cuts. I had to cut my volts back almost to half to finish the job at a close to correct cut height. Is there a setting I might have changed?
CandCNC
Mach3
Sheetcam
Draftsight
Hypertherm65 machine torch
Millermatic 210
Spoolmatic 30a w/ WC-115a
Miller Bobcat 225
http://benzweldingandfabrication.com/
https://www.facebook.com/pages/Benz-Wel ... 468?ref=hl

Rtodahl01
Posts: 68
Joined: Mon Oct 02, 2017 3:39 pm

Re: thc help

Postby Rtodahl01 » Fri Dec 08, 2017 11:05 pm

I have the same issue


Return to “Mach3 CNC”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's