I just recently completed the DHC to DHC2 upgrade along with the switch to Design Edge. I am having trouble with consistent cut heights. Every pierce seems to be at a different height and as it is making longer cuts, the torch keeps plunging into the metal to the point where it shuts down the cut. I am very new to this whole process and am sure it is a simple setting I have wrong. Any help is greatly appreciated.
It is currently Sun Mar 18, 2018 9:14 pm
Post your questions or tips on Plasmacam software in this topic.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests