3.1 and windows 10

Plasmacam software related questions and tips can be posted here
Post Reply
RPM
1/2 Star Member
1/2 Star Member
Posts: 6
Joined: Sat Jul 25, 2009 10:33 pm

3.1 and windows 10

Post by RPM »

Can 3.1 software run on Windows 10, not quite ready for Design Edge
User avatar
1MORECUT
2.5 Star Elite Contributing Member
2.5 Star Elite Contributing Member
Posts: 168
Joined: Wed Mar 31, 2010 6:58 pm

Re: 3.1 and windows 10

Post by 1MORECUT »

I been told it will work on windows 7 and older.

John
Rick Adams
1/2 Star Member
1/2 Star Member
Posts: 2
Joined: Fri Dec 28, 2018 6:44 pm

Re: 3.1 and windows 10

Post by Rick Adams »

I installed 3.11 on my windows 10 computer, Windows 10 would not recognize the PC software. After some research i learned that AXXON Softio sells a PCI port that was developed for Plasmacam, its the LF1119KB PCI card. I ordered the card from Amazon and it arrived 3 days later, installed the card and the PC software showed up instantly. after some emailing back and forth with AXXONs tech support a couple of times to get configuration values set just right i was able to get the machine and my computer to talk to each other. Can't say enough about AXXON their customer support is awesome.

Rick
User avatar
rdj357
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1148
Joined: Sun Mar 11, 2012 4:40 pm
Location: Tahlequah, OK
Contact:

Re: 3.1 and windows 10

Post by rdj357 »

That's great info Rick! I have 3.11 on a Windows 10 computer but it is not the one that I control the table with so I had no personal knowledge of its ability to work with the parallel port part of things.
Metaspec
1.5 Star Member
1.5 Star Member
Posts: 27
Joined: Thu Aug 16, 2018 12:37 pm

Re: 3.1 and windows 10

Post by Metaspec »

windows 10 will work fine with the axon card or the 20.00 amazon card
Post Reply

Return to “Plasmacam - DesignEdge”