I am getting a time out on controller to PC. Running windows 7. Upon start of cut it will run for a bit then time out. The torch will keep firing until I shut the plasma machine off. At that point I shut off the controller and back on to reset but then the table still won't respond.
I have gone to settings and disabled the USB conserve and set the computer to performance. I also put on a new usb cable from the PC to controller. Any ideas out there?
Timing out
-
- 2 Star Member
- Posts: 62
- Joined: Fri Oct 31, 2014 2:04 pm
Timing out
Homebuilt 2x4 water table
Torchmatecad
Flashcut THC
Hypotherm 45
Torchmatecad
Flashcut THC
Hypotherm 45
-
- 2 Star Member
- Posts: 62
- Joined: Fri Oct 31, 2014 2:04 pm
Re: Timing out
Got it figured out separated usb cable and others and all is well,so far.
Homebuilt 2x4 water table
Torchmatecad
Flashcut THC
Hypotherm 45
Torchmatecad
Flashcut THC
Hypotherm 45
-
- 2 Star Member
- Posts: 62
- Joined: Fri Oct 31, 2014 2:04 pm
-
- 2.5 Star Elite Contributing Member
- Posts: 150
- Joined: Tue Apr 17, 2012 3:48 pm
- Location: S/W Louisiana
Re: Timing out
good job figuring it out.