It is currently Mon Dec 18, 2017 5:23 pm

 

Timing out

Post your questions or tips on Torchmates software in this topic.
iron2
Posts: 59
Joined: Fri Oct 31, 2014 2:04 pm

Timing out

Postby iron2 » Mon Aug 17, 2015 12:11 pm

I am getting a time out on controller to PC. Running windows 7. Upon start of cut it will run for a bit then time out. The torch will keep firing until I shut the plasma machine off. At that point I shut off the controller and back on to reset but then the table still won't respond.
I have gone to settings and disabled the USB conserve and set the computer to performance. I also put on a new usb cable from the PC to controller. Any ideas out there?
Homebuilt 2x4 water table
Torchmatecad
Flashcut THC
Hypotherm 45

iron2
Posts: 59
Joined: Fri Oct 31, 2014 2:04 pm

Re: Timing out

Postby iron2 » Mon Aug 17, 2015 5:31 pm

Got it figured out separated usb cable and others and all is well,so far.
Homebuilt 2x4 water table
Torchmatecad
Flashcut THC
Hypotherm 45

iron2
Posts: 59
Joined: Fri Oct 31, 2014 2:04 pm

Re: Timing out

Postby iron2 » Tue Aug 18, 2015 11:02 am

Spoke too soon :(
Homebuilt 2x4 water table
Torchmatecad
Flashcut THC
Hypotherm 45

gs123
Elite Contributing Member
Elite Contributing Member
Posts: 143
Joined: Tue Apr 17, 2012 3:48 pm
Location: S/W Louisiana

Re: Timing out

Postby gs123 » Fri Sep 18, 2015 10:30 am

good job figuring it out.


Return to “Torchmate Software”

Who is online

Users browsing this forum: No registered users and 1 guest