Help With ShopSabre Controller

General software related questions should be posted here.
Post Reply
jkruse715
1/2 Star Member
1/2 Star Member
Posts: 5
Joined: Tue Mar 06, 2018 6:20 pm

Help With ShopSabre Controller

Post by jkruse715 »

I'm new to this forum, new to CNC and new to plasma cutting in fact. I've got a Sidekick 8 from ShopSabre and am running a job. everything stopped in the middle of a job and I'm trying to restart at the line where it quit.

I keep getting the message Error - G28 required for XYZ This is followed by Aborted - EMERGENCY STOP when I try to override, return to Home, etc.

If anyone has any thoughts, that would be great. Thanks!!
fireside
1/2 Star Member
1/2 Star Member
Posts: 2
Joined: Fri Mar 03, 2017 9:01 pm
Location: Unity, Wisconsin

Re: Help With ShopSabre Controller

Post by fireside »

I had this problem as well, sorry but i don't remember what the fix is but is it is a simple one. Call Ben or Logan at shopsabre they will get you going
ShopSabre Sidekick 10
Enroute 6 Software
Hypertherm PM 85
4th Axis Pipe Cutter
Sidekick Router Package

Eplilog Mini Laser Engraver
Coral Draw 8

Hobart 210 Welder

Columbia Coatings Oven
ScottF
1.5 Star Member
1.5 Star Member
Posts: 33
Joined: Wed Nov 29, 2017 10:48 pm
Location: Colorado

Re: Help With ShopSabre Controller

Post by ScottF »

Ben and Logan are great to work with! I am sure you have already but double check to make sure the E stop on the table is not pressed. Rotate it to get it to pop back out if it has been pressed. I believe that is the error message that pops up when you try to run the machine after you press the E stop.
I don't have all the answers but I do have a lot of opinions....


ShopSabre Sidekick 8 with water table
Hypertherm Powermax 85 w/machine and hand torches
IR 5hp 60 gal,+ 60 gallons of storage and aftercooler
Lincoln Square Wave 200
14x40 lathe
JohnnyC
1.5 Star Member
1.5 Star Member
Posts: 46
Joined: Mon Feb 12, 2018 9:13 am

Re: Help With ShopSabre Controller

Post by JohnnyC »

You've had better service than me.
Post Reply

Return to “General Discussion”