It is currently Thu Feb 22, 2018 7:54 am

 

Omniwin Common Line

General software related questions should be posted here.
MichaelM40
Posts: 2
Joined: Wed Jan 17, 2018 3:50 pm

Omniwin Common Line

Postby MichaelM40 » Wed Jan 17, 2018 3:54 pm

Does anyone use Omniwin to nest their parts? I am trying to figure out how to do common line cutting on the table so I can cut down on skeletons and make long rip cuts. If anyone has experience doing that any advice would be appreciated. I just haven't been able to figure out how to enable that feature.

MichaelM40
Posts: 2
Joined: Wed Jan 17, 2018 3:50 pm

Re: Omniwin Common Line

Postby MichaelM40 » Wed Feb 07, 2018 1:45 pm

Update: It was another $6,000 upgrade software package from Messer to be able to do common line cutting and edge start.


Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 1 guest