Omniwin Common Line

General software related questions should be posted here.
Post Reply
MichaelM40
1/2 Star Member
1/2 Star Member
Posts: 2
Joined: Wed Jan 17, 2018 3:50 pm

Omniwin Common Line

Post by MichaelM40 »

Does anyone use Omniwin to nest their parts? I am trying to figure out how to do common line cutting on the table so I can cut down on skeletons and make long rip cuts. If anyone has experience doing that any advice would be appreciated. I just haven't been able to figure out how to enable that feature.
MichaelM40
1/2 Star Member
1/2 Star Member
Posts: 2
Joined: Wed Jan 17, 2018 3:50 pm

Re: Omniwin Common Line

Post by MichaelM40 »

Update: It was another $6,000 upgrade software package from Messer to be able to do common line cutting and edge start.
Post Reply

Return to “General Discussion”