Omniwin Common Line
-
- 1/2 Star Member
- Posts: 2
- Joined: Wed Jan 17, 2018 3:50 pm
Omniwin Common Line
Does anyone use Omniwin to nest their parts? I am trying to figure out how to do common line cutting on the table so I can cut down on skeletons and make long rip cuts. If anyone has experience doing that any advice would be appreciated. I just haven't been able to figure out how to enable that feature.
-
- 1/2 Star Member
- Posts: 2
- Joined: Wed Jan 17, 2018 3:50 pm
Re: Omniwin Common Line
Update: It was another $6,000 upgrade software package from Messer to be able to do common line cutting and edge start.