Hey all, I have a local guy in town that asked me to draw up a file for his hypertherm table running Phoenix *I think*. No problem, export it to dxf as usual then email to him. He called me because the import drawing showed up as just a few lines and 2 curves.
My table is an arclight running sheetcam with mach3 and I have no problems with the file but when he imports to his phoenix software it all goes to hell. Has anyone ran into this? With the phoenix software being so automated I wonder if it is a setting that needs changed, but I do not know the software well enough to diagnose.
Thanks,
Nicholas
Hypertherm Table with Phoenix Software
- MemFor
- 1.5 Star Member
- Posts: 46
- Joined: Mon Nov 16, 2015 9:08 pm
- Location: Southern Illinois
- Contact:
-
- 2.5 Star Member
- Posts: 181
- Joined: Wed Sep 23, 2009 8:54 pm
- Location: Midcoast Maine
Re: Hypertherm Table with Phoenix Software
I don't know how old his system is but I find the dxf ver. should be ver 10 or ver 11 dxf. Might want to check if this is a first time they have tried this. The software does need to have the settings set to accept dxf files. This is set in the config settings. I also use sheetcam and write to the simple Hyperautomation file whick works ok
- MemFor
- 1.5 Star Member
- Posts: 46
- Joined: Mon Nov 16, 2015 9:08 pm
- Location: Southern Illinois
- Contact:
Re: Hypertherm Table with Phoenix Software
Thanks for the reply, from what I can tell after doing research it seems the hypertherm software really doesn't like splines in the dxf and they need to be polylines.
-
- 2.5 Star Member
- Posts: 181
- Joined: Wed Sep 23, 2009 8:54 pm
- Location: Midcoast Maine
Re: Hypertherm Table with Phoenix Software
Arcs lines and circles