It is currently Wed Mar 21, 2018 4:44 am
General software related questions should be posted here.
3 posts • Page 1 of 1
- Elite Contributing Member
- Posts: 208
- Joined: Sun Dec 09, 2012 6:31 am
From my experience, software tracing programs alone will not give satisfactory results. You can easily spot files posted that were traced by software as the files will be huge with thousands of nodes. I use solidworks software and bring in the image and hand trace using lines and arcs. I avoid splines as much as possible. I can easily put in an hour or two on a detailed image trace. After completing the drawing, solidworks allows me to create a 3d model that I can verify and then save out as a dwg or dxf to send to our laser software.
Who is online
Users browsing this forum: No registered users and 1 guest