It is currently Sat Aug 18, 2018 5:09 am

 

machine not responding to offset

General software related questions should be posted here.
falcondan
Posts: 3
Joined: Tue May 08, 2018 8:07 pm

machine not responding to offset

Postby falcondan » Fri Jun 01, 2018 8:45 pm

Hello to the group. Brand new member here and I have been reading a lot and have already been IMPRESSED by what is available here. My Uncle just purchased a Plasmacam DNC 2. Everything is going pretty good but when we try to cut the 1" square to set the X/Y offset, the machine doesn't seem to respond. We keep getting .976" squares. Like 7 of them already! I have tried to change the offset from -0.020 al the way to .1 and we just keep getting .976" squares. (wish there was a market for them!!) Am I missing a command to accept changes, or something else?
Thanks in advance for any ideas!!!
Thank you for this wonderful forum!!
Dan

Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's