It is currently Fri May 25, 2018 8:51 am
General software related questions should be posted here.
2 posts • Page 1 of 1
- Posts: 2
- Joined: Wed Jan 17, 2018 3:50 pm
Does anyone use Omniwin to nest their parts? I am trying to figure out how to do common line cutting on the table so I can cut down on skeletons and make long rip cuts. If anyone has experience doing that any advice would be appreciated. I just haven't been able to figure out how to enable that feature.
Who is online
Users browsing this forum: No registered users and 2 guests