offset plasma cut - plasma kerf compensation

Cut quality issues can be discussed here, most common issues have been discussed here and should help you.
Post Reply
patc
2.5 Star Elite Contributing Member
2.5 Star Elite Contributing Member
Posts: 107
Joined: Sat Nov 14, 2009 3:45 pm

offset plasma cut - plasma kerf compensation

Post by patc »

Hi, thank you to Scratch for helping me with my cut order problem. Maybe someone can help me with a question about offset cutting. I have a Practical CNC table, with a WinCNC controller. I am using Corel draw and I would like to know if there is any way that I can edit files so that it cuts on either side of the line, instead of down the center. I thhink this would help with files that have lines drawn close together.
Thanks, Pat C
Post Reply

Return to “Plasma Cut Quality Forum”