It is currently Thu Jun 21, 2018 10:04 pm

 

Can't Control Carriage

Plasma Cut Quality can often be an issue for many of us. Check here if you have plasma cut quality issues. Ask a question, look for advice, post a helpful tip here.
montanarose
Posts: 27
Joined: Mon Apr 23, 2012 6:07 pm

Can't Control Carriage

Postby montanarose » Sat May 12, 2018 12:26 pm

Hello, went to start cutting this morning & machine would not Initialize. I have a PlasmaCam machine ,, Error keeps saying,, Can't Control Carriage Gentry, Check wiring & if carrage is jammed with item.... I did the xyz test & messed with the cables while machine was running & didnt do anything.. Can anyone help,, of course Customer Support is closed on day I finally need them... Appreciate any help,, Thank You...

jimcolt
Elite Contributing Member
Elite Contributing Member
Posts: 2889
Joined: Mon Jul 20, 2009 11:18 pm
Location: New Hampshire

Re: Can't Control Carriage

Postby jimcolt » Mon May 14, 2018 9:29 am

1. Run the gantry all the way to the back and check that it is not out of square. It should trip the limit switch just before the right side hits the hard stop. If the right side hits first...you will error.

2. Power the control box and computer down, disconnect and reconnect both ends of the parallel cable linking control box to computer and wait about 1 minute, then restart everything.

Generally one of these will solve it.



montanarose wrote:Hello, went to start cutting this morning & machine would not Initialize. I have a PlasmaCam machine ,, Error keeps saying,, Can't Control Carriage Gentry, Check wiring & if carrage is jammed with item.... I did the xyz test & messed with the cables while machine was running & didnt do anything.. Can anyone help,, of course Customer Support is closed on day I finally need them... Appreciate any help,, Thank You...


Return to “Plasma Cut Quality Forum”

Who is online

Users browsing this forum: Google Adsense [Bot] and 3 guests

Easyscriber engrave attachment for Hypertherm torch's