Is this going to cut correctly?

Cut quality issues can be discussed here, most common issues have been discussed here and should help you.
Post Reply
michelle
1 Star Member
1 Star Member
Posts: 10
Joined: Fri Apr 21, 2017 10:46 pm

Is this going to cut correctly?

Post by michelle »

Can someone take a look at this file and tell me if it looks like it will cut correctly? It wasn't right when it was done originally but I 'think' I have it fixed, I just need an expert to check it before I waste more material!

Thanks guys!
Michelle
Attachments
hornet.pcm
(469.17 KiB) Downloaded 75 times
weldguy
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1928
Joined: Fri Apr 17, 2009 11:48 am

Re: Is this going to cut correctly?

Post by weldguy »

Try posting this in the file sharing forum and you will reach more members and likely get the help your looking for. I cannot open pcm files or I would take a look.
michelle
1 Star Member
1 Star Member
Posts: 10
Joined: Fri Apr 21, 2017 10:46 pm

Re: Is this going to cut correctly?

Post by michelle »

I cut it and it worked. Thank you!
User avatar
rdj357
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1156
Joined: Sun Mar 11, 2012 4:40 pm
Location: Tahlequah, OK
Contact:

Re: Is this going to cut correctly?

Post by rdj357 »

Here you go, I cleaned it up and fixed the unlinked paths out in the middle that were piercing on the path. Bridged in some details in the wings that were fallouts, reshaped the left eye and added a touch of detail, thickened the antennae just a little for strength, and scaled back some open path details that were close to cutting to the edge. I do custom file work if I can ever help - robert@490Creations.com

Hope this helps a little!
Hornet.png
Attachments
hornet.pcm
(437.86 KiB) Downloaded 61 times
hornet.dxf
(808.2 KiB) Downloaded 72 times
Post Reply

Return to “Plasma Cut Quality Forum”