It is currently Tue Jan 23, 2018 6:35 pm

 

Fine cut for hypertherm 45?

Plasma Cut Quality can often be an issue for many of us. Check here if you have plasma cut quality issues. Ask a question, look for advice, post a helpful tip here.
Rtodahl01
Posts: 48
Joined: Mon Oct 02, 2017 3:39 pm

Fine cut for hypertherm 45?

Postby Rtodahl01 » Tue Jan 09, 2018 5:53 pm

I have a bunch of nozzles for my hypertherm 45m torch.
Trying to cut 1/4 inch material foes not penatrate at book specs.
I haven't seen any different part number to order other than what I have.
TrI'd slowing down and different voltages.hmm.

Rtodahl01
Posts: 48
Joined: Mon Oct 02, 2017 3:39 pm

Re: Fine cut for hypertherm 45?

Postby Rtodahl01 » Thu Jan 11, 2018 3:36 pm

Bad o ring.
New consumables
Back on track

whiskeymike
Posts: 284
Joined: Mon Feb 23, 2015 5:23 pm
Location: Austin, TX

Re: Fine cut for hypertherm 45?

Postby whiskeymike » Thu Jan 11, 2018 6:00 pm

I didn't think Fine cut was rated for 1/4". According to my manual for a 65, 45amp finecut goes to 10 gauge, less than half the thickness.

The other item to check is if they are legit and not knock off/counterfit consumables.

Rtodahl01
Posts: 48
Joined: Mon Oct 02, 2017 3:39 pm

Re: Fine cut for hypertherm 45?

Postby Rtodahl01 » Fri Jan 12, 2018 7:57 pm

I have only bought hypertherm consumables.
Kinda funny about using factory parts on all my equipment.

jimcolt
Elite Contributing Member
Elite Contributing Member
Posts: 2804
Joined: Mon Jul 20, 2009 11:18 pm
Location: New Hampshire

Re: Fine cut for hypertherm 45?

Postby jimcolt » Sun Jan 14, 2018 10:08 am

The operators manual lists all of the available parts for the Powermax45. There are no Finecut parts for this system. Finecuts are designed for thin gauge with a maximum thickness of 10 gauge (1/8")....so they would not help on 1/4" anyway. Here are the available mechanized consumables. Be sure the part numbers you have match up with these. The Powermax45 will have no trouble piercing and cutting up through 1/2" steel. If you cannot penetrate 1/4" then you may have the wrong consumables, you may have a bad work cable (check connections for continuity), or you could have a missing or damaged torch oring or low inlet air pressure. Jim Colt Hypertherm


mechanized consumables.png

You do not have access to download this dxf file.
Become a Contributing Member to gain access to the thousands of files shared by our members. Click Here



Return to “Plasma Cut Quality Forum”

Who is online

Users browsing this forum: DDamm and 3 guests