CNC plasma cut errors guide? (noob)

Cut quality issues can be discussed here, most common issues have been discussed here and should help you.
Post Reply
singleslammer
1/2 Star Member
1/2 Star Member
Posts: 2
Joined: Mon Aug 07, 2017 3:47 pm

CNC plasma cut errors guide? (noob)

Post by singleslammer »

Hello all,

I have a Dynatorch Super B that I am learning to use. This is my first CNC device having only worked with "dumb" tools in the past. I am looking for a guide of common errors and their causes so I can educated myself without taking up a ton of time on here. I have attached my current issue just to give you an idea of what I am dealing with. This is 1/4" plate mild cut at 65 amps at around 100 ipm if memory serves. Also, this is the back side of the cut. I think my issue was that I tend to use sharp corners where I should have used rounded corners here.

Thanks, Jordan
stampies wheel centers 1.jpg
stampies wheel centers 2.jpg
Post Reply

Return to “Plasma Cut Quality Forum”