I have a Dynatorch Super B that I am learning to use. This is my first CNC device having only worked with "dumb" tools in the past. I am looking for a guide of common errors and their causes so I can educated myself without taking up a ton of time on here. I have attached my current issue just to give you an idea of what I am dealing with. This is 1/4" plate mild cut at 65 amps at around 100 ipm if memory serves. Also, this is the back side of the cut. I think my issue was that I tend to use sharp corners where I should have used rounded corners here.
It is currently Fri Sep 21, 2018 3:51 pm
Plasma Cut Quality can often be an issue for many of us. Check here if you have plasma cut quality issues. Ask a question, look for advice, post a helpful tip here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests