A5 gas? for cutting stainless

Cut quality issues can be discussed here, most common issues have been discussed here and should help you.
Post Reply
tnttracy
2 Star Member
2 Star Member
Posts: 71
Joined: Fri Jun 05, 2015 12:02 pm

A5 gas? for cutting stainless

Post by tnttracy »

all new to me, just heard about it at the lws. reading the spec sheet says its only good to 1/4" and over. i'm really wanting to try it on 10g and have a bottle and gas fitting on order.

anybody have experience, am i throwing my money away?
Attachments
Hypertherm _F5_Cut_Charts.pdf
(191.98 KiB) Downloaded 74 times
jimcolt
5 Star Elite Contributing Member
5 Star Elite Contributing Member
Posts: 3087
Joined: Mon Jul 20, 2009 11:18 pm
Location: North Carolina

Re: A5 gas? for cutting stainless

Post by jimcolt »

edited, new post below!
Last edited by jimcolt on Wed Nov 15, 2017 9:48 am, edited 1 time in total.
jimcolt
5 Star Elite Contributing Member
5 Star Elite Contributing Member
Posts: 3087
Joined: Mon Jul 20, 2009 11:18 pm
Location: North Carolina

Re: A5 gas? for cutting stainless

Post by jimcolt »

You will get angular, drossy cuts if you use this F5 (5% hydrogen, 95% nitrogen) on materials thinner than the cut charts suggest. You can get much nicer cuts on materials thinner than 1/4" when using air or nitrogen as the gas. Jim Colt Hypertherm
jimcolt
5 Star Elite Contributing Member
5 Star Elite Contributing Member
Posts: 3087
Joined: Mon Jul 20, 2009 11:18 pm
Location: North Carolina

Re: A5 gas? for cutting stainless

Post by jimcolt »

You will get angular, drossy cuts if you use this F5 (5% hydrogen, 95% nitrogen) on materials thinner than the cut charts suggest. You can get much nicer cuts on materials thinner than 1/4" when using air or nitrogen as the gas. Be sure you use a regulator at the cylinder to keep the plasma inlet pressure below 135 psi and above 90 psi. Set the gas regulator at about 115psi with gas flowing at the torch for best results. Jim Colt Hypertherm
Post Reply

Return to “Plasma Cut Quality Forum”