It is currently Sat Nov 18, 2017 10:04 pm

 

Stops cutting periodically with 45amp finecut

Plasma Cut Quality can often be an issue for many of us. Check here if you have plasma cut quality issues. Ask a question, look for advice, post a helpful tip here.
DCMW
Posts: 13
Joined: Mon Jul 10, 2017 7:47 am

Stops cutting periodically with 45amp finecut

Postby DCMW » Wed Oct 18, 2017 8:44 am

I have a Hypertherm 65 and primarily use the fine cut 45a tips. But periodically it will just stop cutting while in the middle of cutting, and say that arc voltage was lost or something like that (Plasmacam). But if using a 65a tip, it cuts non stop with no problem. Not sure what to do. Ive lowered the cut height, ive slowed the torch down. Any help is appreciated.

Return to “Plasma Cut Quality Forum”

Who is online

Users browsing this forum: No registered users and 6 guests