It is currently Tue Nov 21, 2017 6:19 pm

 

hyperterm pm 65 code 30-1

Plasma Cut Quality can often be an issue for many of us. Check here if you have plasma cut quality issues. Ask a question, look for advice, post a helpful tip here.
Jordf
Posts: 8
Joined: Mon Sep 23, 2013 12:36 am

hyperterm pm 65 code 30-1

Postby Jordf » Fri Aug 11, 2017 4:40 pm

Hi i have a home built water table with candcnc controls, powermax 65.. When I have longer running cuts, it keeps stopping and showing error code 30-1. Due to crap getting into the tip. Even when my consumables are new!! Its super annoying. Ive tried raising my pierce heights and cut heights, it seems to have helped a bit but the problem still happens at some point.

Any good tips to avoid this? how much higher can I raise the torch over factory hyperthem settings before it causes other problems

Return to “Plasma Cut Quality Forum”

Who is online

Users browsing this forum: No registered users and 2 guests