hyperterm pm 65 code 30-1

Cut quality issues can be discussed here, most common issues have been discussed here and should help you.
Post Reply
Jordf
1/2 Star Member
1/2 Star Member
Posts: 8
Joined: Mon Sep 23, 2013 12:36 am

hyperterm pm 65 code 30-1

Post by Jordf »

Hi i have a home built water table with candcnc controls, powermax 65.. When I have longer running cuts, it keeps stopping and showing error code 30-1. Due to crap getting into the tip. Even when my consumables are new!! Its super annoying. Ive tried raising my pierce heights and cut heights, it seems to have helped a bit but the problem still happens at some point.

Any good tips to avoid this? how much higher can I raise the torch over factory hyperthem settings before it causes other problems
Post Reply

Return to “Plasma Cut Quality Forum”