It is currently Mon Sep 25, 2017 3:49 am

 

Trouble shoot THC

Plasma Cut Quality can often be an issue for many of us. Check here if you have plasma cut quality issues. Ask a question, look for advice, post a helpful tip here.
seajinx
Elite Contributing Member
Elite Contributing Member
Posts: 255
Joined: Fri Oct 31, 2014 8:50 am
Contact:

Trouble shoot THC

Postby seajinx » Fri Aug 11, 2017 11:47 am

What is the procedure (if any) to trouble shoot the THC, to confirm if it is bad or not. I'm sure some has touch on this before but I can seem to find where. I've used the search and haven't found any procedural way to determine if the THC needs to be replaced. Thank you in advance.

User avatar
WyoGreen
Elite Contributing Member
Elite Contributing Member
Posts: 581
Joined: Tue Mar 04, 2014 8:36 pm
Location: Cheyenne, Wyoming
Contact:

Re: Trouble shoot THC

Postby WyoGreen » Fri Aug 11, 2017 8:39 pm

What THC are you using?
Precision Plasma gantry
CommandCNC Linux controller w/Feather Touch & PN200 hand controller
HT-45 plasma cutter
Plate Marker
CNC Router table

tcaudle
Posts: 730
Joined: Tue Feb 28, 2012 6:47 pm
Contact:

Re: Trouble shoot THC

Postby tcaudle » Sat Aug 12, 2017 1:52 pm

This is not a primary hardware support forum. Its just users like yourself that mostly have file or cut issues.
Since you appear to have a Arclight table (I found it from som eof your other posts) I would contact them on how to troubleshoot the THC.
Failing that, you can contact the Support Forum of the THC manufacturer
In any case basic information is needed. Approximate age of the system. Model of the THC, what its doing, can you cut with the THC off
Baseline voltages while cutting.

seajinx
Elite Contributing Member
Elite Contributing Member
Posts: 255
Joined: Fri Oct 31, 2014 8:50 am
Contact:

Re: Trouble shoot THC

Postby seajinx » Sat Sep 16, 2017 5:48 am

I did find the problem, It was the Voltage divider board. Replaced and operation back to normal.


Return to “Plasma Cut Quality Forum”

Who is online

Users browsing this forum: No registered users and 3 guests