so, the past week ive had tons of problems with my Hypertherm HPR260XD.
last week I was having countless problems with cut quality due to my cut height delay resetting to .0sec as well as other possible problems. for the most part however ive solved the issues for cutting 1/2" and below. parts ive been cutting in 1/2 and 3/8ths since have come out perfect, very little dross, nice edges and holes. my 3/4 cuts however are a different story altogether. I'm still getting pretty severe positive bevels as well as intermittent undercuts, I do my best to check and make sure the settings are those outlined in the cutcharts in the manual.
