It is currently Wed Jun 20, 2018 6:59 pm

 

Help with CandCNC Feather Touch Ohmic Sensor

CNC Plasma Cutters are amazing and there is always plenty of knowledge to share and discuss. Use the CNC plasma cutters general forum for this purpose.
Njcnc
Posts: 7
Joined: Tue Aug 29, 2017 11:04 am

Help with CandCNC Feather Touch Ohmic Sensor

Postby Njcnc » Mon May 28, 2018 6:27 pm

Picked up one of these units for my homebrew table after looking around for an ohmic sensing unit. I have it wired up, put power to it, green light is on. I've wired a common from my BOB which is 5v and my float switch into the unit. When I trip the float switch, I can see in linuxcnc the signal go from false to true so all is well. When I trip the ohmic sensing, the sense light lights up orange but I get no output on the "Z home" orange wire.

Am I doing something wrong here? Is the unit supposed to pass the common pin through the Z home wire or something else? I flipped through the manual and couldn't find an explanation on the logic. Also tried to join the candcnc forum but keep getting errors so posting here.

Thanks in advance for any help.
-Stefan

tcaudle
Posts: 973
Joined: Tue Feb 28, 2012 6:47 pm

Re: Help with CandCNC Feather Touch Ohmic Sensor

Postby tcaudle » Tue May 29, 2018 6:40 pm

The Output is am open collector transistor. The input has to have a pullup and it shorts it to common. A basic NPN typ configuration. Common is to the input common of the BoB.

Njcnc
Posts: 7
Joined: Tue Aug 29, 2017 11:04 am

Re: Help with CandCNC Feather Touch Ohmic Sensor

Postby Njcnc » Wed May 30, 2018 2:05 pm

Thanks for the info, just rewired and tested it now, works excellent.

Thanks again
Stefan


Return to “CNC Plasma Cutters General Forum”

Who is online

Users browsing this forum: No registered users and 9 guests

Easyscriber engrave attachment for Hypertherm torch's