It is currently Fri Jun 22, 2018 5:08 pm

 

help wiring a 45xp to proma 150 and Gecko g540

CNC Plasma Cutters are amazing and there is always plenty of knowledge to share and discuss. Use the CNC plasma cutters general forum for this purpose.
bigforkg
Posts: 3
Joined: Sat May 05, 2018 3:49 pm

help wiring a 45xp to proma 150 and Gecko g540

Postby bigforkg » Wed May 09, 2018 8:03 pm

I have looked and found nothing far as the 45xp. My setup. Gecko G540, proma 150 and 45xp Mach3 and sheetcam. It appears to me like connector sockets 3,4 and 5(-),6(+) was switched around by Hypertherm. I could use some help, I don't want to burn up any electronic components.

Where does the 45xp Start machine motion 12,14 go? Start plasma 3,4 go?
Proma 150 Arc go on the G540? output 5?

I have the 45xp Voltage divider 5(-)6(+) the Proma 150 power connection and its voltage divider+,- input, the up, dwn and com figured out.


This is what I do know from the 45xp manual. Start plasma 3,4. Start machine motion 12,14. Voltage divider 5,6. Ground 13.
Proma 150. Outputs: up, Arc, Dwn, com. Power connection + - and arc divider +,-.
Gecko 540: 1,2,3,4 inputs. 5,6 output 12 ground.

bigforkg
Posts: 3
Joined: Sat May 05, 2018 3:49 pm

Re: help wiring a 45xp to proma 150 and Gecko g540

Postby bigforkg » Fri May 11, 2018 11:17 am

Nothing? Tiring to get it going this weekend.

tcaudle
Posts: 976
Joined: Tue Feb 28, 2012 6:47 pm

Re: help wiring a 45xp to proma 150 and Gecko g540

Postby tcaudle » Fri May 11, 2018 11:47 am

Taking a part from vendor A then interfacing it to vendor B and then to to the third vendor , the plasma cutterm will require you find someone that has done that exact hookup and made it work. Someone I am sure has done this but they may not check the list every day,


Return to “CNC Plasma Cutters General Forum”

Who is online

Users browsing this forum: No registered users and 4 guests

Easyscriber engrave attachment for Hypertherm torch's