I’m new!!!!

For general topics and questions that do not fit into any of the other categories or forums.
Post Reply
Burnking
1 Star Member
1 Star Member
Posts: 10
Joined: Fri Feb 09, 2018 7:07 pm

I’m new!!!!

Post by Burnking »

Hello everyone!!!! I’m brand new to this! I picked up my 5X10 Stealthmax plasma table from Arclight about a week ago. I’m not new at running tables. I’m running the hypertherm 85 on single phase.

Soooo.... my first question is, how well does plasma cut copper? Iv cut copper on a laser but never plasma. Looking to cut .040 or .060. Hope to hear back from you! Thanx!!!!
Old Iron
3.5 Star Member
3.5 Star Member
Posts: 681
Joined: Wed Nov 26, 2014 5:12 pm

Re: I’m new!!!!

Post by Old Iron »

It cuts it perfectly
Use an aluminum setting on your Hypertherm cut chart.
Post Reply

Return to “CNC Plasma Cutters General Forum”