Hello everyone!!!! I’m brand new to this! I picked up my 5X10 Stealthmax plasma table from Arclight about a week ago. I’m not new at running tables. I’m running the hypertherm 85 on single phase.
Soooo.... my first question is, how well does plasma cut copper? Iv cut copper on a laser but never plasma. Looking to cut .040 or .060. Hope to hear back from you! Thanx!!!!
It is currently Fri May 25, 2018 4:43 pm
CNC Plasma Cutters are amazing and there is always plenty of knowledge to share and discuss. Use the CNC plasma cutters general forum for this purpose.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests