New plasma table
-
- 1/2 Star Member
- Posts: 2
- Joined: Sat Feb 03, 2018 6:56 am
New plasma table
Looking to build my own plasma table. I already have a thermal dynamics cut master 52. Can build my own table since I Live in AK and shipping one up here would be expensive. So basically I need the gantery and electronics. Im very green to this and any info or links would be appreciated.
- Larry83301
- 5 Star Elite Contributing Member
- Posts: 2647
- Joined: Tue Oct 27, 2009 6:36 pm
- Location: Twin Falls, Idaho
Re: New plasma table
Check out this part of the spider lots of info and pics could be of some help, OK!Akcrawler wrote:Looking to build my own plasma table. I already have a thermal dynamics cut master 52. Can build my own table since I Live in AK and shipping one up here would be expensive. So basically I need the gantery and electronics. Im very green to this and any info or links would be appreciated.
http://www.plasmaspider.com/viewforum.php?f=103
Larry
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 7784
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: New plasma table
PM sent
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
-
- 1/2 Star Member
- Posts: 2
- Joined: Sat Feb 03, 2018 6:56 am
Re: New plasma table
Thank you.
-
- 4 Star Member
- Posts: 780
- Joined: Sun Aug 21, 2016 1:49 am
- Location: Brisbane, Australia
- Contact:
Re: New plasma table
Having built a table from scratch to my own design, it sounds simple but it is not a trivial project if your goal is to produce a commercial quality table. I started with the Z axis because I thought it was the hardest part to build and if I could build it, the rest was a walk in the park.
My abbreviated build in need of an update http://plasmaspider.com/viewtopic.php?f=103&t=22826
Much more info on the LinuxCNC forum. Just search for "spaceship plasma" there.
My abbreviated build in need of an update http://plasmaspider.com/viewtopic.php?f=103&t=22826
Much more info on the LinuxCNC forum. Just search for "spaceship plasma" there.