Hello, I'm new here. Sorry to post a question and not a file. I need to know if the "plasma" DXF files are laser cutter ready?
Thank you!
Laser Cutter ready?
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 7792
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: Laser Cutter ready?
Yes for the file but you will need to run it though a Cam type program to configure the speed and other perimeter for laser. The DXF file is like a map for directions, how you get there is up to the CAM program.
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT