It is currently Sat Nov 18, 2017 1:39 am

 

EZCUT Down Draft Tables?

CNC Plasma Cutters are amazing and there is always plenty of knowledge to share and discuss. Use the CNC plasma cutters general forum for this purpose.
tylerd
Posts: 31
Joined: Fri Jan 20, 2017 3:25 am

EZCUT Down Draft Tables?

Postby tylerd » Fri Oct 06, 2017 9:38 am

Simple question, does anyone own one?, and if so how well does the downdraft design work on it? Pretty simple design with 1 12" hole in the center of the table. Please list your table size and any relevant information.

Thanks in advance!

tylerd
Posts: 31
Joined: Fri Jan 20, 2017 3:25 am

Re: EZCUT Down Draft Tables?

Postby tylerd » Thu Oct 19, 2017 11:25 am

Not a single owner out there than can comment?

User avatar
see&see
Elite Contributing Member
Elite Contributing Member
Posts: 164
Joined: Tue Jun 24, 2014 12:04 pm
Location: Minden, Nevada

Re: EZCUT Down Draft Tables?

Postby see&see » Fri Oct 20, 2017 1:45 pm

12" hole?

I use a 20" hole in the side panel with 4' flex duct directly out the wall into a 3000 CFM fan and it's just enough to keep smoke out of the shop on a 4 x 4 table.
PlasmaCam DHC2 4 x 4 & Sampson 510 Snap 'n Cut w/Safety Switch Interface Hypertherm 85 & 45XP

weldguy
Posts: 63
Joined: Fri Apr 17, 2009 11:48 am

Re: EZCUT Down Draft Tables?

Postby weldguy » Wed Oct 25, 2017 7:06 pm

I don't have an ezcut downdraft but i do use one of the 12" fans sold here on plasmaspider http://plasmaspider.com/shop/vent_combo.html and it works great in my downdraft setup. No smoke! Works awesome.

tylerd
Posts: 31
Joined: Fri Jan 20, 2017 3:25 am

Re: EZCUT Down Draft Tables?

Postby tylerd » Sat Oct 28, 2017 4:22 am

Weldguy, how large is your table?

Chris Slade
Posts: 3
Joined: Thu Nov 09, 2017 5:36 pm

Re: EZCUT Down Draft Tables?

Postby Chris Slade » Thu Nov 09, 2017 9:31 pm

I have a 5x10 down draft. 5000cfm fan, two opens cantered and 1/3 in from each end. Zero smoke.

tylerd
Posts: 31
Joined: Fri Jan 20, 2017 3:25 am

Re: EZCUT Down Draft Tables?

Postby tylerd » Fri Nov 17, 2017 10:52 am

Just scored a 24" tubeaxial fan, I think that should do it!


Return to “CNC Plasma Cutters General Forum”

Who is online

Users browsing this forum: No registered users and 30 guests