Hi all,
Been a while since I posted. I just bought a new CandCNC set up from Tom. Computer and everything with the new DTHC IV. The reason I had to do this was everything I had crashed. so I have no MACH files to pull from. I Know shame on me for not making back ups. I looked on the manuals site but the ESPII section is not functioning. The computer I got from Tom was supposed to all set up, what I found was nothing was set up. I knew I would have to tune the motors but I thought it would be set up for ports and pins. Long sob story short question, does anyone have the proper sequence for the ports and pins set up? I tried to email Tom about this last night but I sure he needs the weekend off so I thought I would ask you guys.
Thanks in advance
Ports and pins for CandCNC controller
- jeeplogic83
- 2.5 Star Member
- Posts: 154
- Joined: Fri Nov 14, 2008 6:52 am
- Location: West MI
- Contact:
- SeanP
- 4 Star Member
- Posts: 950
- Joined: Thu Aug 01, 2013 11:50 am
- Location: Co Kerry, Ireland
Re: Ports and pins for CandCNC controller
Does the master installer off CandCNC site not install port & pins setup?
Powermax XP45
Home built table, Candcnc DTHC 2, Dragoncut 620-4
R-Tech 210 Tig, Jasic 250 mig
Sheetcam, Scanything, Coreldraw
Table build gallery
Home built table, Candcnc DTHC 2, Dragoncut 620-4
R-Tech 210 Tig, Jasic 250 mig
Sheetcam, Scanything, Coreldraw
Table build gallery