We had a small stall in a makers and vintage place, and now we have bigger stall in the place. So far so good, but as always, we ran out of time to finish the setup. Our biz does laser and plasma cut things. Here is a few pictures of the initial set up. Can’t wait to get more things in there.
Market project
-
- 2.5 Star Member
- Posts: 209
- Joined: Mon Jan 13, 2014 10:37 am
- Location: Boronia, Melbourne, Australia
Market project
Home built 3400 x 1400mm (11 and a bit X a bit over 4.5 feet)
Hypertherm Powermax 45
CandCNC Bladerunner IV
Some air dryer off the internet
Another water seperator I found unused on a shelf
Refrigerated air dryer
Hypertherm Powermax 45
CandCNC Bladerunner IV
Some air dryer off the internet
Another water seperator I found unused on a shelf
Refrigerated air dryer
-
- 1.5 Star Member
- Posts: 45
- Joined: Thu Jan 07, 2010 9:23 am
Re: Market project
I like the framed different bat man symbols.