I had to put the table into storage for 10 months and this is the first project done since getting it back working. Not after a few hiccups though. To note, stainless checkerplate is an interesting thing to cut.
First project after 10 month break
-
BensPlasmaAu
- 2.5 Star Member
- Posts: 209
- Joined: Mon Jan 13, 2014 10:37 am
- Location: Boronia, Melbourne, Australia
First project after 10 month break
Hiya all,
I had to put the table into storage for 10 months and this is the first project done since getting it back working. Not after a few hiccups though. To note, stainless checkerplate is an interesting thing to cut.
I had to put the table into storage for 10 months and this is the first project done since getting it back working. Not after a few hiccups though. To note, stainless checkerplate is an interesting thing to cut.
-
Old Iron
- 3.5 Star Member
- Posts: 681
- Joined: Wed Nov 26, 2014 5:12 pm
Re: First project after 10 month break
Nice work!!!
What equipment are you using?
What equipment are you using?
-
BensPlasmaAu
- 2.5 Star Member
- Posts: 209
- Joined: Mon Jan 13, 2014 10:37 am
- Location: Boronia, Melbourne, Australia
Re: First project after 10 month break
DIY table, CandCNC Bladerunner DTHCIV with 620 steppers. The usual programs SheetCAM and Mach3. I have a Hyperthermia PowerMax 45 plasma running on 3 phase 415volt. It's a ripper, eats through heaps thicker than people expect, but I think that's because most have experience with single phase 45's.
