Roses
-
- 2.5 Star Member
- Posts: 135
- Joined: Tue Mar 05, 2013 1:33 pm
- Location: South Haven, Mich.
Re: Roses
I really like them. Are they hard to do? Would you post your dxf and some tips and tricks. Have a Good Week.
Dale...
Dale...
- 99guy
- 1.5 Star Member
- Posts: 26
- Joined: Sun Mar 24, 2013 4:48 pm
Re: Roses
I cant take credit at all here ............
Here is a link to the making of one or these:
http://www.shopfloortalk.com/forums/sho ... php?t=9451
Thanks boilerman !
And the dxf is already on here somewhere, cant remember who posted it but thanks to them ...... maybe they will see this and speak up.
Next time I cut one I'm going to mod the file a little to take some of the sharp points off and maybe reduce the size of the tabs just a touch.
Guess I used two files actually, one just for the leaves.
They take a little time but the results are worth it !
Here is a link to the making of one or these:
http://www.shopfloortalk.com/forums/sho ... php?t=9451
Thanks boilerman !
And the dxf is already on here somewhere, cant remember who posted it but thanks to them ...... maybe they will see this and speak up.
Next time I cut one I'm going to mod the file a little to take some of the sharp points off and maybe reduce the size of the tabs just a touch.
Guess I used two files actually, one just for the leaves.
They take a little time but the results are worth it !
- Attachments
-
- Rose dfx good one.DXF
- (76.47 KiB) Downloaded 151 times
-
- rose leaves 4 sets.dxf
- (45.1 KiB) Downloaded 133 times
TruCutCNC Series1 Gen2 4x8 water
TruTrac THC
Powermax 85 . M85 Torch
TD A120 . SL100SV1
Mach 3 . SheetCam . CorelX6
TruTrac THC
Powermax 85 . M85 Torch
TD A120 . SL100SV1
Mach 3 . SheetCam . CorelX6
- AnotherDano
- 4 Star Member
- Posts: 806
- Joined: Fri Dec 18, 2009 11:52 pm
- Location: Laramie, Wyoming
- Contact:
Re: Roses
'Twas I that posted a file for roses.
And the file was from shopfloortalk,,, probably from Boilerman or one of the many guys who make the roses.
Shame on me for not remembering my source and passing on the credits. Sorry B'man et. al.
And the file was from shopfloortalk,,, probably from Boilerman or one of the many guys who make the roses.
Shame on me for not remembering my source and passing on the credits. Sorry B'man et. al.
Dano Roberts
droberts@ironpequod.com
PlasmaCam DHC-2 v3.11
Hypertherm PowerMax-30
Serving Laramie, Wy since Thursday
droberts@ironpequod.com
PlasmaCam DHC-2 v3.11
Hypertherm PowerMax-30
Serving Laramie, Wy since Thursday