Page 1 of 1

They said jump right in!!!!

Posted: Mon Apr 16, 2018 10:54 am
by RandyGA
Greetings folks. Had to find something to do in my pre-retirement years. Always wanted to do plasma cutting to make things. I am old,LOL, but willing to learn new things. This is where I was told that I could do just that. " If you don't make mistakes, you are not learning " Hope to get a hand up when I fall. From just the short time on here, I can tell talent is not in short supply here. So I would think, yes, you can teach an old dog new tricks :) Send any helpful tips my way. Thanks; Randy

Re: They said jump right in!!!!

Posted: Mon Apr 16, 2018 11:31 am
by rdj357
Welcome to the fun!

Re: They said jump right in!!!!

Posted: Mon Apr 16, 2018 3:31 pm
by acourtjester
Welcome aboard Randy, a CNC table can be used for more then just Plasma cutting, other topics have been discussed here. At 75 I may be the oldest goat :lol: here but still having fun with my table. Many different project have been enhanced by my having a CNC table, and it is great tool to have in the shop. :D Or should I say