Cutting Corrugated steel HELP
-
- 1/2 Star Member
- Posts: 3
- Joined: Fri Feb 02, 2018 10:18 pm
Cutting Corrugated steel HELP
I have searched and have only found one post about this, but it was for Mach3. I have a 4x8 Arclight Dynamics table with a Hypertherm 45. I am running Sheetcam and CommandCNC for software. I want to cut some letters out of corrugated metal and have no idea how to make the THC follow the curves of the metal. Any advised would be appreciated. Thanks
- tnbndr
- 4.5 Star Elite Contributing Member
- Posts: 1670
- Joined: Mon Jan 09, 2012 4:30 pm
- Location: New Berlin, WI
- Contact:
Re: Cutting Corrugated steel HELP
I would contact Arclight. I think there are settings in the SheetCam or Mach3 that need to be changed to speed up the response of the THC.
Dennis
LDR 4x8, Scribe, DTHCIV
Hypertherm PM45, Macair Dryer
DeVilbiss Air America 6.5HP, 80Gal., 175psi, Two Stage
16.9scfm@100psi, 16.0scfm@175psi
Miller 215 MultiMatic
RW 390E Slip Roll (Powered)
AutoCAD, SheetCAM, Mach 3
http://ikescreations.com
LDR 4x8, Scribe, DTHCIV
Hypertherm PM45, Macair Dryer
DeVilbiss Air America 6.5HP, 80Gal., 175psi, Two Stage
16.9scfm@100psi, 16.0scfm@175psi
Miller 215 MultiMatic
RW 390E Slip Roll (Powered)
AutoCAD, SheetCAM, Mach 3
http://ikescreations.com
-
- 4 Star Elite Contributing Member
- Posts: 1184
- Joined: Tue Aug 25, 2015 12:05 pm
- Location: Central MO, USA
Re: Cutting Corrugated steel HELP
Bulltear 6x12 w/ Proton Z axis & watertable
CommandCNC/Linux w/ Ohmic & HyT options
Hypertherm Powermax 85 w/ machine torch
Solidworks, Coreldraw X7, Inkscape, Sheetcam
CommandCNC/Linux w/ Ohmic & HyT options
Hypertherm Powermax 85 w/ machine torch
Solidworks, Coreldraw X7, Inkscape, Sheetcam