Feathertouch & torch volts
- djreiswig
- 4.5 Star Elite Contributing Member
- Posts: 1946
- Joined: Thu Nov 19, 2015 10:02 pm
- Location: SE Nebraska
Feathertouch & torch volts
I installed the FeatherTouch ohmic sensor on my table and now my torch volts don't go to zero when I'm not cutting. It fluctuates from 0 to 1 or 2 volts while it is sitting. If I disconnect the wire from the shield it will go to zero and stay there. I don't think it is affecting anything as far as cutting goes, I just think it is weird. Is the cutter getting feedback from the ohmic voltage and causing this? Is there something I need to re-calibrate?
2014 Bulltear (StarLab) 4x8
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)