It is currently Fri Jan 19, 2018 11:54 pm
CandCNC plasma table components discussion forum
1 post • Page 1 of 1
- Posts: 175
- Joined: Thu Nov 19, 2015 10:02 pm
I installed the FeatherTouch ohmic sensor on my table and now my torch volts don't go to zero when I'm not cutting. It fluctuates from 0 to 1 or 2 volts while it is sitting. If I disconnect the wire from the shield it will go to zero and stay there. I don't think it is affecting anything as far as cutting goes, I just think it is weird. Is the cutter getting feedback from the ohmic voltage and causing this? Is there something I need to re-calibrate?
Who is online
Users browsing this forum: No registered users and 1 guest