Cut Profile

CandCNC plasma table components discussion forum
Post Reply
metalfixer
1 Star Member
1 Star Member
Posts: 10
Joined: Wed Oct 04, 2017 3:59 pm

Cut Profile

Post by metalfixer »

Is there a way to add the cut profile back to the screen, we had to reload everything on the computer.
The 'Cut Profile' was there, now all it indicates is 'stored information', and clicking does nothing.
Running Mach3 and the MP-3000 THC.
Thanks,
Larry
tcaudle
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1353
Joined: Tue Feb 28, 2012 6:47 pm

Re: Cut Profile

Post by tcaudle »

Cut profile first reads the stored settings in the DTHC and shows them as the Current Profile. If it can't talk to the DTHC via the serial port (on the MP3000) then it you can't make changes or save anything. You MUST have DTHC ONLINE indicator ON to use the Cut Profiles.
metalfixer
1 Star Member
1 Star Member
Posts: 10
Joined: Wed Oct 04, 2017 3:59 pm

Re: Cut Profile

Post by metalfixer »

Thanks Tom,
The one I was asking about was like a chart that showed metal type, metal thickness, type of tip, fine cut etc.
Is this what you were referring too?
Thanks,
Larry
tcaudle
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1353
Joined: Tue Feb 28, 2012 6:47 pm

Re: Cut Profile

Post by tcaudle »

Cut Profile is a display of the SheetCAM tooltable that can be used as a LOCAL settings load for the DTHC parameters. Its OVERRIDDEN by the valuse in the G-code from SheetCAm using the Proper POST. Some values that are GLOBAL Common to all Profiles ) are set there .
Largemouthlou
4 Star Member
4 Star Member
Posts: 1402
Joined: Mon Aug 30, 2010 5:56 am
Location: Palm Bch Gardens Fl
Contact:

Re: Cut Profile

Post by Largemouthlou »

If you haven't already figured this out you can choose a different screen and it should have the cut profile dro on it, then save.
1250 hypertherm
4 X 8 Precision Plasma
CandCnC electronics
tcaudle
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1353
Joined: Tue Feb 28, 2012 6:47 pm

Re: Cut Profile

Post by tcaudle »

on the MACH setups the Cut Profile button is in the Tab Flyout ...not the main screen.
Post Reply

Return to “CandCNC Forum”