It is currently Thu Oct 19, 2017 6:47 am
Discussion forum for Lincoln & Miller plasma cutters
3 posts • Page 1 of 1
I was wondering if anyone had the cut chart for a miller spectrum 2050 being used on a plasmacam 4x4 wigh dhc2. I currently have the settings to cut 16gauge at I believe .07 cutting height, 40 amps and 110-120ipm. I am getting a lot of dross that is not easy to clean up. I also wanted to say thanks for an awesome forum, it's sites like these that convinced me to get in to the cnc plasma cutting world. Any help would be greatly appreciated for a newbie.
I'm still a newb my self but have you tried using 30 amp tips and slowing it down. Its my understanding you can get dross from running to fast and its harder to remove than dross from running to slow. I also have a 2050.
Users browsing this forum: No registered users and 1 guest