I have a PlasmaCAM DHC2. I am cutting with a Miller Spectrum 375. What I am looking for is a complete configurations listing for different metal thickness. The Spectrum 375 is a new cutting machine for me. I had helped a friend whth his machine before buying mine. He was using a Hypertherm 600. What I would like if possible is the configurations for 16, 18, 20 gauge cold rolled steel. Below I have made a list of the settings I need.
Cutting speed (ipm):
Cutting height ( inch):
Height for rapid travel (inch):
Height for pierce (inch):
Time spent piercing hole (sec):
Continue cutting after stop (sec):
Z shift (inch):
Arc voltage shift (inch):
Material thickness (ga): 16, 18, 20.
Thank you for your time. Any help you could give me would be appreciated.
It is currently Wed Sep 19, 2018 11:09 am
Discussion forum for Lincoln & Miller plasma cutters
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests