It is currently Tue Oct 17, 2017 2:38 pm

 

PLASMA SKIPPING DURING CUTTING

Burn Tables plasma table discussion forum
tdalechick
Posts: 48
Joined: Mon Jul 30, 2012 9:52 pm
Location: TEXAS
Contact:

PLASMA SKIPPING DURING CUTTING

Postby tdalechick » Sat Oct 06, 2012 11:41 am

I have attempted about 10 squares redrawn about 5 times with no broken lines and every time my torch gets to cutting good and then it skips. What is causing this problem??? Burn tables has been no help in clearing up this problem for me. I am getting fustrated and I am new to this. Really hoping I can get this problem solved today. Any help would be appreciated.
-I am using a Hypertherm 45 with a burn table with dhc.

cstroke
Posts: 88
Joined: Thu May 24, 2012 7:45 pm
Contact:

Re: PLASMA SKIPPING DURING CUTTING

Postby cstroke » Sat Oct 06, 2012 1:09 pm

Try turning your height control off and cutting one.. manually keep your height around 1/8"..

If it cuts then it's a problem with your height control.. This might not be your answer but you can start eliminating problems..

Is your ground hooked directly to the piece you are cutting?

wickedinhere
Elite Contributing Member
Elite Contributing Member
Posts: 722
Joined: Thu Jun 09, 2011 9:03 pm
Contact:

Re: PLASMA SKIPPING DURING CUTTING

Postby wickedinhere » Sun Oct 14, 2012 9:52 pm

Low air pressure?


Return to “Burn Tables”

Who is online

Users browsing this forum: No registered users and 1 guest