Table arriving later this Month, advice ?

Don't see your table manufacturer listed above? Post here in this forum.
Post Reply
pitbumpers
1.5 Star Member
1.5 Star Member
Posts: 39
Joined: Sun May 14, 2017 7:59 pm

Table arriving later this Month, advice ?

Post by pitbumpers »

I am new to burning, our 5x10 with rotary, and scribe should be here by the middle of the month. Any advice for the new guy? We will be making brackets for bumpers 1/2" plates. Coping cuts for upright pieces. We have bend tech program, but I am not to happy, because we have square tubing to cut, and burn holes into and the program is not working out. Or I am to dumb to figure it out. Any help would be great !!!
tcaudle
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1352
Joined: Tue Feb 28, 2012 6:47 pm

Re: Table arriving later this Month, advice ?

Post by tcaudle »

Without knowing more about your table and how the rotary is implemented and controlled its not possible to offer possible solutions.
tcaudle
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1352
Joined: Tue Feb 28, 2012 6:47 pm

Re: Table arriving later this Month, advice ?

Post by tcaudle »

Duh! I should have noticed which sub forum this is in.....LDR. Dan can help you address the square tube cutting issue. LDR has more experience than most with building and using rotary plasma cutting. Bendtech may or may not be the answer for non-round cutting.
pitbumpers
1.5 Star Member
1.5 Star Member
Posts: 39
Joined: Sun May 14, 2017 7:59 pm

Re: Table arriving later this Month, advice ?

Post by pitbumpers »

Thanks !!
Post Reply

Return to “Various Manufacturers Forum”